Phrozen Wax-Like Resin (LCD UV Curing Resin): Easy to Print & Cast for Dental and Jewelry Mold Casting, Applicable to 3D Printer, Dark Green (500g);

Specification & Performance

• Weight: 500g per bottle
• XY Resolution: 0.047 mm
• Layer Height / Parameter: 12 sec @ 50 um, Delay 2
• Way to Clean Printed Part: Use alcohol spray to clean models and dry it by air gun. Do not immerse printed part into alcohol over 30 sec.
• Compatible Printer: Phrozen Shuffle, Shuffle XL, Make ParaLED, Make XL ParaLED
• Application: Lost-wax Casting for Jewelry & Dental
• Key Performance: 
  • Viscosity: 680 mPa.S (25C)
  • Density: 1.21 g / cm3
  • Hardness: Shore 65D

• Avoid sun light exposure.
• After printing, stored used resin in closed and opaque bottle.
• DO NOT mix fresh resin and used resin. 
• Shake or stir resin properly to avoid pigment separation.

• DO NOT dump resin. Please cured resin and treat/recycle it as general plastics garbage.

• Do your best to wear glove, goggles, long sleeves shirt during usage of resin. Wash hands after every operation.
• DO NOT swallow resin. Go to hospital if you do it.
• Avoid eye contact by resin. Rinse with water and go to hospital if resin contacts eyes.
• Resin might cause slight skin irritation. Stop using it if allergy occurred.
• Resin smells. We strongly suggest you to use it under ventilated condition.
• Keep resin in room temperature(15 - 35 Celsius) and dry condition.
• Keep resin away from kid.