Phrozen Engineering Series: TR250 High Temp Resin (LCD UV Curing Resin) for Engineering, Industrial Use, Jewelry and Dental Application, Applicable to 3D Printer, Deep Gray (500g);

Specification & Performance

• Weight: 500g per bottle
• XY Resolution: 0.047 mm
• Layer Height / Parameter: 15 sec @ 50 um, Delay 3
• Way to Clean Printed Part: Use alcohol spray to clean models and dry it by air gun. Do not immerse printed part into alcohol over 30 sec.
• Compatible Printer: Phrozen Shuffle, Shuffle XL, Make ParaLED, Make XL ParaLED, Phrozen 1.5
• Application: Rubber Mold for Jewelry, Fine Details GK Kit, Heat Resistance Application
• Key Performance: 
  • Viscosity: 61 mPa.S (25C)
  • Density: 1.10 g / cm3
  • Tensile Stress (Break): 68 MPa
  • Elongation: 8.5%
  • Tensile Modulus: 1050 MPa
  • Hardness: Shore 80D
  
  About Resin Operation
  • Avoid sun light exposure.
  • After printing, stored used resin in closed and opaque bottle.
  • DO NOT mix fresh resin and used resin. 
  • Shake or stir resin properly to avoid pigment separation.
  • DO NOT dump resin. Please cured resin and treat/recycle it as general plastics garbage.
  

  Safety Recommendation
  • Do your best to wear glove, goggles, long sleeves shirt during usage of resin. Wash hands after every operation.
  • DO NOT swallow resin. Go to hospital if you do it.
  • Avoid eye contact by resin. Rinse with water and go to hospital if resin contacts eyes.
  • Resin might cause slight skin irritation. Stop using it if allergy occurred.
  • Resin smells. We strongly suggest you to use it under ventilated condition.
  • Keep resin in room temperature(15 - 35 Celsius) and dry condition.
  • Keep resin away from kid.