Fotag 1 to 3 OBD2 OBDII 16 pin Splitter Extension Cable Male to Female Y J1962 Cable 1.7FT

Spec:
ACC mode Input: 13V-36V | Output: 5V/2.1A
Surveillance mode Input: 11.6V-36V | Output: 5V/2.1A
Extension cable: 3.5meter (11.5 ft) length
Interface: USB

Working Mode:
Mode "O":
ACC mode, when your car ACC is off, the OBD power cable will also power off after 5 minutes.
Mode "- ":
Surveillance mode, when you car ACC is off, the OBD power cable will keep working until detecting the car battery voltage is at 11.6V(low voltage),it will power off after 30 seconds.
The low voltage protection for mode "-" protect your car from running out the battery, enable you have enough voltage to start the car for next driving.

Attention:
1.If you leave your car for many days no driving without surveillance purpose, we suggest you to set the working mode in ACC mode "O".Cars battery will run out day by day because your dashcamera are consuming power all the time in surveillance mode "-".
2.From our clients feedback,the cable work well with most of the European cars, but DON NOT with all Chevrolet or GM vehicles,and some Japanese models,as these vehicles may use different OBD definitions,it may cause your dashboard warnings,we also attach a incompatible list for your reference.
2015 Chevy impala limited,2015 Chevy Silverado,Chevy Tahoe,Chevy Volt,2018 Chevrolet Cruze,2010 or newer Chevrolet or GMC Yukon
2015 Jeep Grand Cherokee,2018 Jeep compass
2014 Toyota Corolla,2011 Toyota Sienna,Toyota Tundra
Tesla Model S
Ford Flex
2018 Mazda 3 Sedan
2004 BMW X3
2017 Hyundai Sonata
2012 Subaru tribeca

Designed to free up your cigarette lighter socket and supply a 24 hours continuous power to your dash camera via OBD connection, enable your dashcam to keep working on after you have parked the car.
Dual working mode switch button integrated for your convenience: 1.ACC working mode,5 minutes off when your car ACC is off; 2. Surveillance working mode, keep working until it detects low battery voltage(11.6V).
Obtaining power from ODB interface only, no interference in other ODB data communication.
Universal USB interface,can be used for any dash cameras with USB output,also it supports to charge devices like mobile phone ,GPS Navigator,power bank with USB output.
Note:1.If the working mode is not switching properly in some vehicels,please unplug and plug the cable from the OBD port then restart the car again;2.For some dashcams our cable may not work properly with them, please refer to incompatible brand list in the product description.
Designed to free up your cigarette lighter socket and supply a 24 hours continuous power to your dash camera via OBD connection, enable your dashcam to keep working on after you have parked the car.
Dual working mode switch button integrated for your convenience: 1.ACC working mode,5 minutes off when your car ACC is off; 2. Surveillance working mode, keep working until it detects low battery voltage(11.6V).
Obtaining power from ODB interface only, no interference in other ODB data communication.
Universal USB interface,can be used for any dash cameras with USB output,also it supports to charge devices like mobile phone ,GPS Navigator,power bank with USB output.
Note:1.If the working mode is not switching properly in some vehicels,please unplug and plug the cable from the OBD port then restart the car again;2.For some dashcams our cable may not work properly with them, please refer to incompatible brand list in the product description.

Top WaffleMaker Reviews

REARMASTER Universal OBD Power Cable for Dash Camera,24 Hours Surveillance/Acc Mode with Switch Button(USB Port);