ECO-WORTHY CNC Z-Axis Tool Setting Touch Plate Probe Compatible with Mach3 and Other Router Mill;

Specification:
Material: wire + metal
Size: approx. 1.38*0.78inch/3.5*2cm (Diameter* Height)
Effective surface of the knife: 25mm/0.98inch (Diameter)
Cable length: approx. 4ft/120cm (Including alligator clips)

Two ways to connect this item:
If your interface board has the limit switch port or other probe port, you can connect it to that port.
If your interface board does not have that port, your driver board has that port, you can connect it to the driver board's limit switch port.
Then in the Mach 3, you need to setup the probe (Mach3 --- Config---Ports and Pins---Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero. in the attachment, it is the code, you can edit it as your requirements.

Usage:
The wire connect on the control panel interface.
The clip and the control board GND (negative) is connected.
The tool can be clamped portion of the operation when the knife with a clip.
When the tool contacts the knife that the process is complete.

Package included:
1x CNC Router Engraving Machine Tool