Providing state of the art results in flush trimming. The bit uses a double ball bearing pilot to run against your project template while the up cut flutes pull chips up and away from the router, leaving a smooth bottom surface.
- TOOL SPECS: Solid carbide, upcut, flush trim spiral with 1/2" cutting diameter, 1/2" shank, 2" cutting length, and 4-3/4" overall length for use in routers with a 1/2" collet.
- FLUSH TRIM: For precise, clean flush trim cuts in hardwoods, laminates, plywood, particle board, solid surfaces, and composites for smooth results.
- UP CUT SPIRAL: The spiral helix gently slices through wood grain to ensure clean, crisp cuts while outperforming standard straight bits.
- TEMPLATES: For following templates, duplicating shapes, and creating intricate designs, especially when using a router table with the template positioned above the workpiece.
- DOUBLE BEARING: Features double bearings for enhanced stability and reduced strain on the bearings.
- TOOL SPECS: Solid carbide, upcut, flush trim spiral with 1/2" cutting diameter, 1/2" shank, 2" cutting length, and 4-3/4" overall length for use in routers with a 1/2" collet.
- FLUSH TRIM: For precise, clean flush trim cuts in hardwoods, laminates, plywood, particle board, solid surfaces, and composites for smooth results.
- UP CUT SPIRAL: The spiral helix gently slices through wood grain to ensure clean, crisp cuts while outperforming standard straight bits.
- TEMPLATES: For following templates, duplicating shapes, and creating intricate designs, especially when using a router table with the template positioned above the workpiece.
- DOUBLE BEARING: Features double bearings for enhanced stability and reduced strain on the bearings.
