Feature：
compatible pump part number 190593GS, 190635GS and 203640GS.
1/8" -27 male BSP thread.
Made of brass
Package List: 2 x Brass Barbs; 2 x Check Valve Balls; 2 x Springs; 4 x O-Rings.
How to Replace
1. Follow soap hose to end and you'll find injector. Take off soap hose.
2. Use wrench to remove old injector. Clean out any gunk or dried soap in receptacle.
3. Make sure rubber o ring is on injector as pictured. Put ball bearing inside injector and then the spring with small end of spring against the ball bearing.
4. Insert injector into receptacle and tighten injector with 13mm wrench. Don't overtighten, you'll break the o ring or crack white metal on pump.
5. Put the soap hose back on.
Compatible Below Pressure Washer
Troy-Bilt pressure washer:
020200-0, 020207-0, 020207-1, 020208-0, 020208-1, 020213-0, 020240-0, 020240-2, 020241-0, 020242-0, 020242-2, 020242-4, 020245-0, 020245-1, 020245-2, 020292-3, 020293-0, 020293-1, 020294-0, 020295-0, 020296-0, 020316-2, 020337-0, 020316-0, 020316-1, 020381, 01903.
- Package: two chemical injector sets include two brass barbs with 1/8 inch-27 male BSP thread, two check valve balls, two springs and four o-rings
- Compatible: Pressure washer soap injector kit is compatible with Pump 190593GS, 190635GS and 203640GS
- Function: If the part on your pressure washer pump is worn out, rusted or hard water deposit clogged, you can replace it with this set
- Attention: When you insert injector into receptacle of pump and tighten injector with 13 mm wrench, don't overtighten, you'll break the o ring or crack white metal on pump
- Warm Tip: Please check the part number of your pressure washer pump and make sure the soap injector matches your pump
- Package: two chemical injector sets include two brass barbs with 1/8 inch-27 male BSP thread, two check valve balls, two springs and four o-rings
- Compatible: Pressure washer soap injector kit is compatible with Pump 190593GS, 190635GS and 203640GS
- Function: If the part on your pressure washer pump is worn out, rusted or hard water deposit clogged, you can replace it with this set
- Attention: When you insert injector into receptacle of pump and tighten injector with 13 mm wrench, don't overtighten, you'll break the o ring or crack white metal on pump
- Warm Tip: Please check the part number of your pressure washer pump and make sure the soap injector matches your pump
