Branger HTV Vinyl Rolls - 12 Inch × 5 Feet PU Heat Transfer Vinyl, Easy Cut & Weed Compatible with Cameo Silhouette & Cricut, Iron on Vinyl for DIY T-Shirts, Bags and Other Textiles (Black);

Instructions for Use:

1. Choose your desired design , you must flip your design before cutting

2. Reverse the pattern and cut it onto the vinyl sheet with a craft cutter.

3. Weed out the excess

4. Heat and Transfer

Place the sheet with your design on to your shirt and place the teflon sheet on the top of your design.

5. Cool Peel

Peeling the clear pet film after the vinyl turns cold, just in 15-30 seconds later for the vinyl to cool down.

*If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl.

Home Iron:

- Please Heat the iron on medium setting (302°F- 320°F);

- Press each section of the design with medium/firm pressure for 10-15 seconds;

Heat Press：

- Preheat garment for 2-3 seconds;

- Apply design at 305°F;

- Use medium pressure for 10-15 seconds;

 

Craft Cutter Setting:

- Cricut

Blade: Standard; Setting: Iron-On

- Silhouette Cameo

Blade: 3; Speed: 8; Force: 4; Passes: 2; Material: Smooth

- Brother

Blade: 1; Cut Speed: 1; Cut Pressure: 1

*Settings may vary based on blade condition and age of machine.

Please Note:

1. Make sure there are no wrinkles on the material.

2. If you are having trouble, try turning the shirt 90 degrees and pressing again, this should eliminate problems from cold spots.

3. If you've already ruined one shirt, keep using it to experiment. Cut small pieces of heat transfer and try raising or lowering your temperature, or pressing longer or for less time.

4. Please wait for at least 24 hours to wash your design.