Xmifer Stud Finder Sensor Wall Scanner - 4 in 1 Multi Function Electronic Stud Sensor Finders Wall Detector Center Finding with LCD Display for Wood AC Wire Metal Studs Detection;

Xmifer stud finder are committed to providing solutions that get reliable and consistent results. 

1.Feature:

• Ergonomic design and soft grip provide comfort and control of the tool.<>
• Upgraded sensor technology to get the most accurate and fast results<>
• HD graphical LCD display indicates detection mode, center pointing, low battery in dication etc, easy to read.<>
• Auto calibration function to provides users with maximum reliability.<>

2.How to use Xmifer stud finder?

Step 1: Calibrate the tool before every scan

Placeunit flat on the wall, press power button to power on, press the Scan button(on the right side of the tool) to start calibration. Wait for the reducing bars disappears and beeps to confirm calibration has completed.

Instud/deep mode, put it on the wall where you want to detect to calibrate it ;In AC/Metal mode, put it in the air to calibrate it.

Note:It is important to wait for calibration to complete (2-3 seconds) every time.

Step 2:

Choose the scan model at first, hold down the button, then move the stud finder alongthe wall slowly, The narrow on the screen together with the beep signal alter, guides you to find the location of the stud.

Note:

1.if shake or lift the scanner coincidentally, the device needs to bere-calibrate.

2.ifyou can not scan the object from left to right, please try to scan up and down.

Step 3: Find the location of the stud

When the signal bar is full and the beep alarm is loudest, it means you have found the center of an object. Mark it with your pencil.

Then choose the Metal Scan mode to test whether it is a metal. After you confirm that it is not a metal, it means that you found the center of a stud.

Please note: The 9v battery is not included in thepackage.