Our punch dies are sized to non-conduit sizes, in other words, actual/measured hole sizes. In other words, a 1/2" punch and die produced a measured hole size of 1/2".
This distinction is important as the common application of a punch and die is when an electrician punches out a conduit hole, which is measured by the inner diameter of the conduit pipe, not by the outer diameter of the hole produced.
TEMCo TH0372 Punch & Die Set, Non-Conduit 5/8 3/4 7/8 1 1.125 1.25 1.375 1.50 1.625 1.75 1.875 2.00;
Our punch dies are sized to non-conduit sizes, in other words, actual/measured hole sizes. In other words, a 1/2" punch and die produced a measured hole size of 1/2".
This distinction is important as the common applic...
Similar Products
