Woodworking Hold Fast Hold Down Bench dog clamp for 3/4” dog hole(5/8" diameter shaft) (one single holdfast);

Hold Fasts for woodworking. Built for standard 3/4" hole. These are hand forged out of 5/8" solid round bar Ideal for 1-1/2" or thicker bench top. If you have specific requirements we can customize some aspects of these. Woodworkers in Santa Fe, NM buy them from me and love them. Approximately 4-1/2" throat and 12" from top of arc to end of shaft. One recommendation I had was to texture the shaft. I leave them unpolished, but I do not texture. Feel free to modify them as you wish. Some people do rough them with sand paper. These are of forged steel (they will not break like the chinese cast iron) and at a significantly lower cost than even those of well known high quality tool makers such as Lie Nielson. Thank you so much for all the feedback! Any questions or suggestions are welcome and appreciated! *****There is another seller on Amazon posing with my pictures and a false description. This may have led to confusion. This post is for one holdfast and each is personally hand forged. Beware of higher priced false ads. This is the second time its happened. Amazon used to correct these but they no longer do according to their replies*** Please contact me if you have any questions! Thanks! -Bill Kight