Package included:
1 x Mavlink LED controller
6 x RGB LED strip
1 x USB to UART module
Stickers
Cables
User manual
Features:
The Mavlink LED Controller includes a controller board, 6 sets highlight LED strips and one USB to UART module.
It is compatible with any flight controller with ardupilot or PX4 firmware like Pixhawk serial, APM serial, Pixracer, NAVIO2, PXFmini etc. It is compatible with Mavlink 1 and Mavlink 2.
The front 2 LEDs (F1 and F2) show the orientation of the aircraft and get solid when the aircraft arm, breathe when disarm. The color is changeable via the configurator.
The rear 2 LEDs (R1 and R2) show the status of the aircraft(GPS, RC failsafe, low battery, critical low battery, flight mode changing). Refer to the table below for more information about the aircraft status.
Other 2 LEDs (F3 and F4) show solid color. The color is changeable via the configurator.
All LEDs can Turn on/off via one of the Ch6 to Ch16.
Aircraft status LED (R1 and R2) states
Color----Pattern----Description of the state
green---Blinking slowly---GPS locked
blue-----Blinking slowly---GPS not lock
yellow--Blinking quickly---Low battery
pink-----Double blinking---RC failsafe
red------Blinking quickly---Critical low battery
White---Blinking once------Flight mode changing
pink and yellow---Blinking alternatively---RC failsafe and low battery
pink and red-------Blinking alternatively---RC failsafe and Critical low battery
The LED strip will alternately flash when not receiving the Mavlink message. It will work normally when receiving the Mavlink message.
Specification:
Rating current:
200mA @8 LED beads
300mA @12 LED beads
600mA @26 LED beads.
Cable length for LED: 350mm
Max support 4 LEDs for one strip
