10A Solar Charge Controller, Solar Panel Controller 10amp 12V/24V Auto Paremeter Adjustable LCD Display Solar Panel Regulator with Dual USB Load Timer Setting ON/Off Hours;

Please connect battery terminals to the charge controller before connecting the solar panel to the charge controller. NEVER connect solar panel to the controller UNTIL the battery is connected !!!

NOTE:
1.DO NOT connect any inverters or battery charger into the load terminal of the charge controller.
2.Refer to the technical specification for the Max.current value and Max.wire size passing over the controller. Make sure the total input voltage and power does not exceed.
3.Make sure your battery has enough voltage for the controller to recognize the battery before first installation.

Features:
12V/24V auto work
LCD screen display
Two USB output
Easy operation interface
PWM charging mode
short-circuit protection
Battery reverse discharge protection
Battery reverse polarity protection
open-circuit protection
Overload protection

Parameters:

1. Floating charge Voltage(HVD 13.3V-15V)
2. Recovery after under Voltage(LVD 11V-13.5V)
3.Under Voltage protection (RVD 9V-12.3V)
4.Load Mode(24hours,1-23hours,0hour)
5.Battery Option (GEL,LEAD-ACID,FLOODED)

Batt voltage: 12V/24V auto
Charge current: 10A
Discharge current: 10A
Max Solar input: <50V
Equalization: B01 sealed 14.4V
B02 Gel 14.2V
B03 flood 14.6V
Float charge: 13.7V(defaul,adjustable)
Discharge stop: 10.7V(defaul,adjustable)
Discharge reconnect: 12.6V(defaul,adjustable)
USB output: 5V/3A
Self-consume: <10mA

System Connection:
1.Connect the battery to the charge regulator - plus and minus.
2.Connect the photovoltaic module to the regulator - plus and minus.
3. Connect the consumer to the charge regulator - plus and minus.
NOTE: The reverse order applies when deinstalling! An improper sequence order can damage the controller!

Package:
1.1X 10A Solar Charge Contorller
2.1X User Manual