[Packing List]
1 x ESP32 WROVER IPEX Development Board
[Overview]
Geekworm ESP32 WROVER-i DevKit is a low-footprint, minimal system development board which is powered by our latest ESP32-WROVER ipex module and can be easily adjusted to a breadboard, and build in ESP32-WROVER Module ipex version module.
[New and Powerful]
Built around the ESP32-WROVER Module IPEX module, this minimal system development board achieves optimal performance with its rich peripheral set, Wi-Fi and Bluetooth radio solutions, which are offered by our latest SoC, the ESP32. The limit is your imagination!
[Rapid Prototyping]
Get right into application design and development without worrying about RF performance and antenna design. The DevKitC has your basic system requirements already covered. Just plug in the USB cable and you're good to go!
[Flexible and Feature-Rich]
The WROVER DevKit contains the entire basic support circuitry for the ESP32-WROVER Module, including the USB-UART bridge(CH340), reset- and boot-mode buttons, LDO regulator and a micro-USB connector. All pin export GPIO is available to the developer.
[More details & Download]
Pleaser refer to our wiki: www.raspberrypiwiki.com/index.php/ESP32_WROVER-i_DevKit
- Geekworm ESP32 WROVER-i DevKit is a low-footprint, minimal system development board which is powered by our latest ESP32-WROVER PCB module and can be easily adjusted to a breadboard, and build in ESP32-WROVER Module PCB version module.
- Built around the ESP32-WROVER Module PCB module, this minimal system development board achieves optimal performance with its rich peripheral set, Wi-Fi and Bluetooth radio solutions, which are offered by our latest SoC, the ESP32. The limit is your imagination!
- Get right into application design and development without worrying about RF performance and antenna design. The DevKitC has your basic system requirements already covered. Just plug in the USB cable and you're good to go!
- The WROVER DevKit contains the entire basic support circuitry for the ESP32-WROVER Module, including the USB-UART bridge(CH340), reset- and boot-mode buttons, LDO regulator and a micro-USB connector. All pin export GPIO is available to the developer.
- Trouble shooting(also in the last description below) & Download: Pleaser refer to our wiki: www.raspberrypiwiki.com/index.php/ESP32_WROVER-i_DevKit
- Geekworm ESP32 WROVER-i DevKit is a low-footprint, minimal system development board which is powered by our latest ESP32-WROVER PCB module and can be easily adjusted to a breadboard, and build in ESP32-WROVER Module PCB version module.
- Built around the ESP32-WROVER Module PCB module, this minimal system development board achieves optimal performance with its rich peripheral set, Wi-Fi and Bluetooth radio solutions, which are offered by our latest SoC, the ESP32. The limit is your imagination!
- Get right into application design and development without worrying about RF performance and antenna design. The DevKitC has your basic system requirements already covered. Just plug in the USB cable and you're good to go!
- The WROVER DevKit contains the entire basic support circuitry for the ESP32-WROVER Module, including the USB-UART bridge(CH340), reset- and boot-mode buttons, LDO regulator and a micro-USB connector. All pin export GPIO is available to the developer.
- Trouble shooting(also in the last description below) & Download: Pleaser refer to our wiki: www.raspberrypiwiki.com/index.php/ESP32_WROVER-i_DevKit
