A2212 2200kv Motor Specification:

KV: 2200
Ri(M Ω): 0.033
Battery: 2-3Li-Po
Max Power: 342W
Test Prop: 7x3/7x4
Motor Size: 27.5x38mm/1.08''x1.5''
Shaft Diamete...

Buy Now From Amazon

A2212 2200kv Motor Specification:

KV: 2200
Ri(M Ω): 0.033
Battery: 2-3Li-Po
Max Power: 342W
Test Prop: 7x3/7x4
Motor Size: 27.5x38mm/1.08''x1.5''
Shaft Diameter: 3.17mm/0.12''

30A Brushless ESC Specification:
BEC: 3A
Constant Current: 30A.
Max Current: 45A (less than 12s).
Low-voltage Cutoff: Auto detect.
Input: 2-3 LiPo or 5/10 NiMH.

Package Included:
1 X A2212 2200kv Brushless Motor
1 X 30A Brushless ESC
2 X Propeller
1 X Macroporous pulp(fit for Bullet)
1 X Holes pulp(fit for Pulp protection)

1 X Bag of Fitting



Attension: when first time to use this ESC and motor replacement or you are not skillful or professional to play RC Plane Quadcopter Helicopter , Plese follow these steps to set your throttle stroke calibration.otherwise incorrect operating will cause ESC hot ,smoke or burn

How to set Throttle stroke calibration:
1.Connect the ESC with motor ,another end connect with receiver.
2.Turn on the remote controller and push the throttle to the highest point
3.Plug the ESC into batteries
4.There has double click sound (the highest point of the throttle confirm)
5.After get the click sound take the throttle stick to the lowest point
6.Confirm the three click sound  that means OK
Note: The three lines of the brushless ESC can be connected at will. If the steering is not correct, you can adjust any two of them.

Note2:.Please allow 1-3mm error due to manual measurement. pls make sure you do not mind before you purchase


  • Name: Brushless Motor; Model : A2212-6; KV : 2200RPM/V
  • Motor Part Size : 27.5 x 38mm/ 1.08" x 1.8"(L*D); Shaft Size : 3.17mm/ 0.12"
  • Fit for Battery : 2-3 Li-Poly, Fit for ESC : 30A
  • 30A ESC Input Voltage: 2-3 cells lithium battery or 5/10NIMh battery
  • Suitable for RC Glider Quadcopter Helicopter Aircraft Copter Multi-copter
  • Name: Brushless Motor; Model : A2212-6; KV : 2200RPM/V
  • Motor Part Size : 27.5 x 38mm/ 1.08" x 1.8"(L*D); Shaft Size : 3.17mm/ 0.12"
  • Fit for Battery : 2-3 Li-Poly, Fit for ESC : 30A
  • 30A ESC Input Voltage: 2-3 cells lithium battery or 5/10NIMh battery
  • Suitable for RC Glider Quadcopter Helicopter Aircraft Copter Multi-copter

Similar Products

Hobbypark Φ1.2mm x L180mm (7.1 inch) Steel Z Pull / Push Rods Parts for RC Airplane Plane Boat Replacement (Pack of 10)J-Deal 5X Pcs SG90 Micro Servo Motor 9G RC Robot Helicopter Airplane Boat ControlsWMYCONGCONG 15 Nylon Control Horns 21x11 mm + Pushrod Connector Linkage Stopper 1.3mm + 1.2 x 180mm Steel Push Rods Parts for RC Airplane PlaneOvonic 11.1V 2200mAh 3S 50C Lipo Battery with Deans Plug for RC Car Boat Truck Heli Airplane Quadcopter Helicopter Multi-Motor Hobby DIY PartsSmraza 10 Pcs SG90 9G Micro Servo Motor Kit for RC Robot Arm Helicopter Airplane Car Boat Control, Arduino Project30A RC Brushless Motor Electric Speed Controller ESC 3A UBEC with XT60 & 3.5mm bullet plugsYbee 10x Pcs SG90 Micro Servo Motor Mini SG90 9g Servo For RC Helicopter Airplane Car Boat Robot controlsJ-Deal® 10x Pcs SG90 Micro Servo Motor 9G RC Robot Helicopter Airplane Boat Controls