Runcam TX200U FPV Transmitter 1S 3.5-5.5v 5.8G 48CH 25/200mW Video Transmitter for Nano/Micro Sparrow/Micro Swift 2/Micro Eagle;

parameter
Working Current: 5V150~400mA
Video Input Impedance: 75 Ohm
Frequency Channel: 5.8G 48CH
Voltage out: 5Vmax 250mA / Voltage in: 1S 3.5-5.5V
Antenna: U.FL 5.8G 2dB Omni antenna
Lightweight: 2.5g (with antenna), PCB Size: 19mm*19mm

Frequency Setup
Lock mode:
Red LED flashes, only 25mW Bandamp; limited frequency available;
Unlocked mode:
Red LED keeps on, 200mW Bandamp; all 48 channels available; By long pressing button for 10 seconds, you can switch between the two modes.

Note:
Before you get TX200 unlocked, it is highly recommended to know about the rules and regulations in your country about the frequency to avoid a fine or confiscation of your device.
1 Blue LED for Channel
Short press the button to switch the Channel, Channel 1/2/3/4/5/6/7/8 in sequence. For each short press, the Blue LED flashes once, and only when it's under the Channel 1, the LED is always on.
6 Red LED for Band
Long press the button two seconds to switch the Band, Band 1/2/3/4/5/6 in sequence.For each long press, the six Red LEDs light in turn.
1 Orange LED for Power
Long press the button five seconds to switch the power, on is 200mw, off is 25mw, lock mode is limited to 25mw.

Remote control
If you need to get 200mW Bandamp; all 48 channels unlocked, please long press the button on VTX for 10 seconds till the red LED is always on.

Package Including
1 * TX200U Transmitter
1 * Set of screws