[Gulfcoast Robotics] Rear Mounted Z-Brace Frame Support Kit for Wanhao Duplicator i3 Plus and Maker Select Plus 3D Printers;

IMPORTANT: This kit is compatible with PLUS 3D Printer ONLY, for V2.1 3D Printer Zbraces purchase ASIN B07B3X1XH8.

Our new kit is rear mounted and will allow better access to print platform.

In our kit we use ball joints to eliminate any tension created by misalignment between upper and lower bracket. Off shelf M5 ball rod ends are making our Z-brace design simple and clean looking.

Convenient feature of our kit is ability to allow fine adjustment of the each Z-rod length. Z-Brace rod design is based on turnbuckle principle - each rod will extend and contract by turning tube clockwise or counterclockwise. When you are done with adjustment - just tighten counter nuts on each rod end to get rid of any small play and you will make your adjustment permanent. After you tighten counter nuts your frame will become completely solid and stable.