Attention Please
•Look for a professional person to install the screen
•Test the screen by inserting the flex to the main board before installation; be sure you feel a gentle snap. If not, try again.
•Confirm the phone is power off before installation.
•Refer to the installation tutorial on the YouTube
•Do not press the left and upper corners of the screen, otherwise may cause lines on the screen.
•Each screw should be installed into original location, because they are not same length! Never tighten screw over limit!
•Treat flex cables gently, use tools instead of your finger during installation , otherwise the screen will damage!
If you meet with these issues
Cannot turn on, touch insensitive, flash, lines on screen, ghost click etc.
Please try this: Power off your phone, disconnect all the cables including the battery cable, clean the connector on the motherboard, reconnect the cables, leave the phone alone for a while in a dry environment, a hard reset of your phone power on.
Package included
1* iPhone 7 4.7inch black LCD screen
1* screen protector
1* installation manual
1* set repair tools (As below)
  1 * Premium ☆ Screwdriver (1.2 x 30mm)
  1 * Premium ☆ Screwdriver (0.8 x 30mm)
  1 * Premium + Screwdriver (1.2 x 30mm)
  1 * Premium Y Screwdriver (0.6 x 30mm)
  1 * Premium - Screwdriver
  1 * anti-static tweezers
  1 * Ultra-thin Steel pry tool
  1 * Nylon pry tools
  2 * Open Repair Pry Tools
  1 * Plastic guitar picks
  1 * Suction Cup
  1 * SIM Card Tray Opener
  1 * Ultrafine Microfiber Cleaning Cloth
  1 * Set of Replacement Adhesive
Attention Please
•Look for a professional person to install the screen
•Test the screen by inserting the flex to the main board before installation; be sure you feel a gentle snap. If not, try agai...
Similar Products
