Universal Helmet Shield Anti Fog Film,Clear Visor Lens Insert Fog Resistant 3.7" x 10.7";

Youtube Website：https://youtu.be/vIgK58LHNx
Warning:
- The WeePro anti-fog visor insert is made of soft plastic. Please handle it carefully.
- The glue is very strong after full installation. Do not press too hard on the glue until you get the right position for the insert. It can't be reused. Do not peel it off after 24 hours.
- If you need to clean the insert during the period of use, you can use plain water or mild handwashing soap with a soft fabric to avoid scratching/damage.
- This product contains small parts that may cause suffocation if swallowed by children.
the Installation Guide as follows:
Wash your hands and find a clean dry surface, open the package clean up your helmet visor with the soft fabric, ensure that your helmet visor is clean and dry.
Step 1: Remove the Positioning Mask with the red tag from the WeePro Anti-fog Visor Insert, and take care to keep the rest clean.
Step 2: Remove the "Remove" labels, then install the Positioning Mask on the outside of your visor to guide the Anti-Fog insert. Adjust it freely until the "+" is at the middle of your visor.
Step 3: Remove the visor from your helmet, turn its inside upwards. Flex the insert, then align the "+" on the insert with the "+" on the Positioning Mask. Next Important Step, make the insert contact with the middle of your visor, then push the insert from the middle to both sides with your two hands gently.
Step 4: Use one hand to fix the visor, use another hand's finger with the soft fabric to press the glue around for the best adhesion
Step 5: Remove the Protective Film Mask with the blue tag. Remove the Positioning Mask with the red tag.
Step 6: Installation complete, enjoy using your helmet without condensation on the visor and thank you for purchasing a WeePro product.