Ethernet Adapter for Streaming Media 🔥 Sticks (2nd Gen) and Media Devices (2017), 4K Sticks (2019), USB Network Adapter USB Power Supply Cable Plus OTG Cable Adapter Included- xlent;

Xlent Combo includes the USB Adapter, and Ethernet USB adapter for easy install. Plug and play installation 100% brand new and high quality. Supports 10/100 Mbps auto-sensing capability USB 2.0 interface Supports Auto MDIX (straight and cross network cable auto-detection) Support s USB full and high speed modes with bus power capability IEEE 802.3, 802.3u, and 802.3ab (10Base-T, 100Base-tx, and 1000 Base-T) compatible Supports both full-duplex and half-duplex operation in fast Ethernet Supports Jumbo packet of up to 9KB Supports suspend mode and remote wake-up via link-up and magic packet Female RJ45 jack supporting Auto MDIX Embedded 20KB SRAM for RX packet buffering and 20KB SRAM for TX packet buffering. ............... if you have any issues..... I have had some Streaming Devices - Media Stick not connecting to the internet when using the Ethernet cable rather than Wifi. The most common cause is that the Ethernet cable was connected after the Streaming Devices - Media Stick was powered on and the Wifi may be trying to connect. Here are a few suggestions on how to get the Streaming Devices - Media Stick to connect to the internet with the Ethernet. Easiest First: Remove the Power Cable from the Streaming Devices - Media Stick. Connect the Ethernet cable to the Streaming Devices - Media Stick, and the other end to your router. Power the Streaming Devices - Media Stick back on. This will usually correct the issue of the Streaming Devices - Media Stick connecting to the internet over Ethernet. If this does not work then... You Can Also Check the Settings: Connect one end of an Ethernet cable to you Streaming Devices - Media SticK and the other end to your router. In the Screen go to Home screen, select Settings > System > Network > Wired. This Should select the wired network as you primary internet connection.