iPhone 7 Screen Replacement For Lcd Touch Screen Digitizer Frame Assembly Set with 3D Touch Oli & Ode Free Tool Set Include (White) 4.7 inch;

iPhone 7 White Screen Replacement 4.7 Inch by Oli & Ode

Installation: 
1. If the Touch ID no longer works. The touch ID actually nothing relate to the new screen, that's might because of too much force to pry the little fingerprint connector off, you must be Really Really Really careful not to tear the cables. They hold your Touch ID information.
2. Please test it by inserting the flex to your motherboard before installation, be sure you feel a gentle snap. If not, then try again,or the cable will not be connected properly and will not work functionality.

If your phone meet some problems like cannot turn on,touch insensitive, flash, lines on screen etc, please follow below steps: 
1.Please check the LCD to make sure the flex cables are in good condition and there are no debris on the connector. 
2.Disconnect and reconnect the flex cables from the motherboard side. 
3.Then Reboot: Hold buttons (Home, Up volume, and Power button) untill the phone switch down and then switch up again. 
4.Make sure IOS has been upgraded to the latest version. 
5.Leave the phone alone for a while in a dry environment. Sometimes there is static after installing that will go away after some time. Please leave phone alone overnight and see if this problem persists in the morning. 

Package Include: 
1* iPhone 7 White 4.7 inch Inch LCD replacement assembly kit
1* Set Repair Tool Kits,

Warning: No protection & Inappropriate installation may cause injury. Please follow installation guide step by step.
1.Check bubble bag before open it. If found break, Please contact Amazon or Seller for exchange.
2.Please switch off phone to avoid any electrical injury before installation.
3.Not charge phone to avoid any electrical injury during replacement.