BitScope BNC Port Adapter for Bitscope 10 (SP01A);

SP01A is a dual channel BNC adapter for BitScope Mini. It allows the use of industry standard oscilloscope probes. It also supports simultaneous use of the logic inputs and connection to the waveform and clock generator outputs. The SP01A adapter connects via the BitScope Smart Port allowing 1:1, 10:1, 100:1 and other standard attenuating oscilloscope probes as well as current, differential or any other type of BNC terminated sensor designed for use with 1MΩ/20pF oscilloscope inputs. The BNC sockets are supplied with ring nuts and washers so SP01A can be bench mounted. The logic, waveform generator and clock signals appear on the 16-pin header between the BNC sockets. The analog inputs are replicated on the 16-pin header and every input has an associated ground pin below it (for twisted pair connection). Two terminator plugs are included to ground any pair of inputs or to route the waveform generator and/or clock outputs to the BNC sockets. FeatureSpecification Analog Inputs (Standard Probe) 2 Analog Inputs (Twisted Pair) 2 Logic Inputs (3.3V/5V) 6 Comparator Channels 2 (via analog inputs) Waveform Generator 1 (via L4) Clock Generator 1 (via L5) Input Impedance (Analog) 1M Ω / 20pF Input Impedance (Digital) 100k Ω / 5pF Voltage Range (Direct) -7.5 V ~ +10.8 V (1:1 probe) Voltage Range (Scaled) -75 V ~ +108 V (10:1 probe) Device ConnectionIDC -26 (Smart Port) Power Requirement None Pass Through Power 5V (via pin 2) Operating Temperature 0 °C to 40 °C Storage Requirements -40 °C ~ +40 °C / 5 % ~ 95 % RH Dimensions (W x D x H) 60 x 50 x 20 mm Weight (Net) 32g