iPhone 6S Screen Replacement P-zone 3D Touch LCD Display Digitizer Full Pre-assembled Kit (Include Home Button, Front Camera, Ear Speaker, etc) with Repair Tools and Screen Protector;

Note:
1) Only fit for iPhone 6S 4.7 inch
2) This part does include the home button, front facing camera, earpiece speaker, and the LCD shield plate.
3) you need to transfer the home button from you original screen onto this display assembly
to retain the touch ID/Fingerprint identification function if your original home button was not damaged.
4) Please test all items before installation for the screen is easily broken,so carefulness is an indispensable part while installing.
5) If you meet any problems and questions,please contact us as soon as possible,We are here to provide you the best service all the time.

Main Parts:
1 x Screen Replacement for iPhone 6S
1 x Tempered Screen Protector

Repair Tools:
1 x Suction Cup
1 x Dust Wipe
1 x Sim card pin
2 x Triangle Pry Pick
1 x Philips screwdriver
1 x Pentalobe screwdriver

Please pay attention to :
- Please check the LCD to make sure the flex cable is in good condition and there is no debris on the connector.
- When reassembling your phone,please power off, and flex cable should connect one by one to the phone motherboard dock well.
- The display data cable may pop off its connector. This can result in white lines or a blank screen
when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone.
- Mark down all the screws you remove while disassembled the screen, incorrect placement
of these screws during reassembly Will cause permanent damage to your iPhone's logic board.