U-Sky Sew or Iron on Embroidered Patches | Explore Outdoors Park Ranger Save The Nature Designs | Adventure Ready Durable | Outdoor Enthusiasts Campers Hikers | Jackets Backpacks Gear | 3x2.7inch 3PCs;

Embroidered Iron On Patch

Theme: Explore Outdoors
Size: 3.0x2.7 inch
Perfect for Jeans, Jackets, Vests, Hats, Backpacks, Scrapbooking and more

How to Use?

1:Examine the fabric of your clothing or accessory.
Fabrics like denim and cotton provide the best base for iron-on patches.
Look at the fabric care label to see whether it can be ironed (if not, there will be a crossed-out icon of an iron).
Be very careful with polyester fabrics, since applying the high heat necessary for ironing on patches can burn the fabric or cause it to get discolored
Silk and other delicate fabrics are not good candidates for patches

2:Lay the base item on a flat, heat-resistant surface.

3:Place the patch in the position you chose.
The adhesive side should be flat against the base fabric. Make sure that isn't crooked.

4:Heat up an iron
Turn it to the hottest setting your fabric can tolerate. Make sure the "steam" option is turned off

5:Place a thin towel over the patch
The towel will protect the patch itself and the surrounding fabric

6:Position the heated iron over the patch and press down
Hold the iron there for about 15 seconds. Apply as much pressure as you can by pressing down firmly

7:Remove the iron and allow the patch to cool
Check to see whether the patch is fixed on securely by gently rubbing at the edge with a finger, trying to lift it. If it lifts up a bit, replace the towel and press it with the iron again for 10 seconds.


NOTICE
Consider sewing around the edges
This greatly reduces the chances that the patch will fall off.
Don't wash the article more than necessary
Take care not to let the article get too dirty, since washing it may cause the patch to start coming off. Cold water. Air dry.