3/4" SMOOTH GALVANIZED COIL ROOFING NAILSÂ to Bostitch CR19GAL & Senco M003101
Make sure your tool model will accommodate 3/4" length.
For the best results we recommend using MAX CN450R, CN445R, CN445R2, CN445R3
PLEASE NOTE: Because of their extremely short length 3/4" coil roofing nails may tumble in the chamber when fired causing the nail to come out sideways. This cannot be prevented even with coil roofing nailers that claim to accept 3/4" length. Please be aware that 3/4" coil roofing nails may not fire accurately 100% of the time. If this is a concern please use 7/8" length.
Our Coil Roofing Nails are manufactured according to the roofing industry specifications. These nails are 3/4" length 15 degree wire collated with a head diameter of .375" (3/8" diam) Made of .120" (11 gauge) SMOOTH shank Electro Galvanized steel. Electro Galvanized steel provides a very thin layer of coating with a measure of protection against the elements. Over time these nails may corrode. Commonly used in composition asphalt shingles applications. Not recommended for ACQ Treated Lumber. Each Box contains approximately 3,600 nails.
Applications Include:
Asphalt and fiberglass shingles for both new roofs and reroofing. Also for attaching waterproof tar paper, roofing felt, metal drip edges, insulation board, cementitious fiber board products and vinyl siding.
- 3/4" smooth galvanized coil roofing nails, 15° wire collation, 0.120" smooth shank, 3/8" head, diamond point, 3,600 nails per box. Manufactured to roofing industry specifications. Please verify nailer compatibility before ordering.
- Meets ASTM F1667; electro galvanized finish provides thin protective coating with limited corrosion resistance. Nails may corrode over time when exposed outdoors or to moisture.
- Applications: asphalt and fiberglass shingles, roofing felt, waterproof tar paper, metal drip edges, insulation board, cementitious fiber board products, and vinyl siding.
- Not recommended for ACQ treated lumber. Electro galvanized nails offer only minimal protection; for exterior use in high moisture conditions, stainless steel or hot dip galvanized nails are preferred.
- 3/4" smooth galvanized coil roofing nails, 15° wire collation, 0.120" smooth shank, 3/8" head, diamond point, 3,600 nails per box. Manufactured to roofing industry specifications. Please verify nailer compatibility before ordering.
- Meets ASTM F1667; electro galvanized finish provides thin protective coating with limited corrosion resistance. Nails may corrode over time when exposed outdoors or to moisture.
- Applications: asphalt and fiberglass shingles, roofing felt, waterproof tar paper, metal drip edges, insulation board, cementitious fiber board products, and vinyl siding.
- Not recommended for ACQ treated lumber. Electro galvanized nails offer only minimal protection; for exterior use in high moisture conditions, stainless steel or hot dip galvanized nails are preferred.