No battery, No onboard electronics, Just the pure pickups.
3 Transducer Pickup System fit for most string music instruments, amplify an upright bass, banjo, violin, ukulele, viola, cello, mandolin, classical guitar, and a resonator guitar.
No Battery Required, No Soldering Required, pre-wired piezo mic save time for you, easy to install, convenient to use.
Material: Plastic
Electronic Part: Metal
Color: black lines, silver tone
Cable Length: approx. 57cm/ 22.44"
3-pack Piezoelectric Disk Dia.: approx. 27mm/ 1.06"
Endpin Jack Dia.: approx. 6mm / 0.24"
Package Contents:
1 x Pickup
1 x cable fixed mount square
6 x Celluloid guitar picks
Instruction:
1. Take the plastic film down from the back of transducer to expose the adhesive
2. Place the transducer through the sound hole to the lower part of the front body where the guitar produces the best tonal response
3. Drill a hole from inside the body, loosen the end-pin jack nut, insert it to the hole and tighten the nut
Tips:
★Where is the best place to stick the mics ?
Depends on what instrument you are trying to mic. Most instruments the best placement will be directly underneath the saddle/bridge.
★What is the little square plastic piece for ?
You can thread the wire tie thru it in place, then stick the square out of the way and secure the excess cable to it.
★How to use the Self-adhesive ?
Remove the plastic film from the back of the transducer to expose the adhesive.
No battery, No onboard electronics, Just the pure pickups.
3 Transducer Pickup System fit for most string music instruments, amplify an upright bass, banjo, violin, ukulele, viola, cello, mandolin, classical...
Similar Products
