A custom made thermistor encapsulated into an easy to use cartridge package.
Using E3D's proven Semitec 104GT thermistors, which are then potted into a cylindrical copper cartridge with a high conductivity ceramic based adhesive.
The legs are insulated with fibreglass sleeving, and terminated with a Molex Microfit 3.0 connector.
This makes it particularly easy to disconnect your entire HotEnd without the need for re-wiring, especially when used with our high-precision heater cartridges.
A cable for connecting the thermistor to the board is also included.
- Direct replacement of cartridge type thermistor in E3D hotends.
- A custom made thermistor encapsulated into an easy to use cartridge package.
- Genuine Semitec 104GT thermistors used.
- Comes with (1) Hotend Thermistor with attached connector and (1) connector cable measuring 40 inches (101cm)
- Direct replacement of cartridge type thermistor in E3D hotends.
- A custom made thermistor encapsulated into an easy to use cartridge package.
- Genuine Semitec 104GT thermistors used.
- Comes with (1) Hotend Thermistor with attached connector and (1) connector cable measuring 40 inches (101cm)
