* To prevent hardening, the anaerobic adhesive should be in contact with air. A large 120ml container was filled with 50ml of contents. There is only half of the bottle, but the contents are 50ml. * Safety Precautions Keep out of reach of children. * Preparation Protect work area. Parts to be sealed must be clean and dry. Shake the product thoroughly before use. Note: To prevent the product from clogging in the nozzle, avoid touching the bottle tip to the metal surface. * Application For Thru Holes: Apply several drops of the product onto the bolt at the nut engagement area. For Blind Holes: Apply several drops of the product down the internal threads to the bottom of the hole. Assemble parts and tighten as required. Sets in approximately 10 minutes and fully cures in 24 hours. * Cleanup Clean adhesive residue immediately with a damp cloth. Cured product can be removed with a combination of soaking in methylene chloride and mechanical abrasion such as a wire brush. For disassembly, shear with standard hand tools and remove with methylene chloride. In rare instances where hand tools do not work because of excessive engagement length, apply localized heat to nut or bolt to approximately 482°F (250°C). Disassemble while hot.
* To prevent hardening, the anaerobic adhesive should be in contact with air. A large 120ml container was filled with 50ml of contents. There is only half of the bottle, but the contents are 50ml. * Safety Precautions Keep o...
Similar Products
