Mookis Glue Puller Sets Tabs, 30PCS Pro Pulling Tabs Paintless Kits for Dent Removal Repair;

How to use?
1. Clean the dent with a clean wet cloth;
2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes; (please note: the glue gun is not included)
3. Glue a Tab with hot melt glue:
- Use Hammer: Glue a Pulling Tab with hot melt glue on it's back by glue gun tool.
- Use Bridge Puller: Glue the middle tab of Bridge Puller set with hot melt glue on it's back by glue gun tool.
4. Put the Tab with hot melt glue at the center of dent fast, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter);
5. Pull out tabs:
- Use hammer: Screw the hammer to find a perfect range for the spring which can pull the tab out. Then pull out the tabs directly.
-Use Bridge Puller: Adjust the three screws' height to find a perfect place for the Bridge Puller, then pull out the tabs directly.
6. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
7. Use the plastic shovel to remove the glue stuck on the machine body. And then clean the repaired place with a clean wet cloth.

Package content:
10 X Black Pro Pulling Tabs
10 X Rose Pro Pulling Tabs