How to use?
1. Clean the dent with a clean wet cloth;
2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes;
3. Glue a Tab with hot melt glue:
- Use Lifter or T-shaped repairer : Glue a Pulling Tab with hot melt glue on it's back by glue gun tool;
- Use Bridge Puller: Glue the middle tab of Bridge Puller set with hot melt glue on it's back by glue gun tool;
4. Put the Tab with hot melt glue at the center of dent fast, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter).
5. Pull out tabs:
- Use Lifter: Screw the rotary axis of the Lifter to find a perfect range for the spring which can pull the tab out. Then press the handle to pull out the tabs directly;
- Use Bridge Puller: Adjust the three screws' height to find a perfect place for the Bridge Puller, then pull out the tabs directly;
- Use T-shaped repairer: Align the T-shaped repairer and press the drawing tabs with hot melt glue, pull the sliding rod backwards to pull up the dent;
6. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen;
7. Use the plastic shovel to remove the glue stuck on the machine body. And then clean the repaired place with a clean wet cloth. We recommend having rubbing alcohol on hand as well to use to remove the glue that sticks to the vehichle.
Package content:
5 X Yellow Glue Sticks
5 X Black Glue Sticks
How to use?
1. Clean the dent with a clean wet cloth;
2. Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minut...
Similar Products
