NOTE: for your safety, let the professional electrician assist in the installation!Device is very simple(Look at the picture), Wires need to solder, or install shark teeth. Convenient thread stuck switch.Do not understand the installation, please do not buy
- Floor Pedal Switch: long 63mm,wide 26mm,high 14mm
- Property: the voltage 220V power is less than 100W
- Suitable: table lamp, floor lamp switch, opening and closing
- Installation: installation will cut wire stripping and both ends of the connection at both ends of the switch, forced press tight can be, such as strength is small, can use a small hammer knock in place, once closed tightly will very difficult to open, identifying the lines connected after the card again tight!
- Note: for your safety, let the professional electrician assist in the installation!
- Floor Pedal Switch: long 63mm,wide 26mm,high 14mm
- Property: the voltage 220V power is less than 100W
- Suitable: table lamp, floor lamp switch, opening and closing
- Installation: installation will cut wire stripping and both ends of the connection at both ends of the switch, forced press tight can be, such as strength is small, can use a small hammer knock in place, once closed tightly will very difficult to open, identifying the lines connected after the card again tight!
- Note: for your safety, let the professional electrician assist in the installation!
