Normally this shaft only comes with shaft and lower bearing. We have also included upper bearing, pulley locknut, spacer, and blade bolt/washer to make this a complete shaft assembly. If only replacing shaft no need to remove housing from deck. Makes it much easier to install because mounting bolts frequently break when removing the spindle housing. Very Important to install with the spacer (187690) in the proper position. It must go between the pulley and upper bearing. If installed without the spacer or installed with the spacer above the pulley (a common mistake) the shaft and pulley will fail in a short amount of time. Note on blade bolt...This bolt replaces bolt part number 174365, it is a flat washer. If you need bolt 193003 (cupped washer) use your old bolt or order 193003 (ASIN B00IA6MY8M)
Normally this shaft only comes with shaft and lower bearing. We have also included upper bearing, pulley locknut, spacer, and blade bolt/washer to make this a complete shaft assembly. If only replacing shaft no need to remov...
Similar Products
