Instructions: Simply drill a hole slightly larger than the outside diameter of your via of choice and insert the via. Â Via can easily be ground down if required to the desired length and center punched on the shaft side of the circuit board to spread that side of the shaft. Â After this it can be soldered into place or whatever you might wish to do. Â Alternately, you may choose to even grind off the head and you will be left with an extremely discrete shaft only. Â Â Tip: If you wish to grind these down you can either use sandpaper or a rotary tool.
Instructions: Simply drill a hole slightly larger than the outside diameter of your via of choice and insert the via. Â Via can easily be ground down if required to the desired length and center punched on the shaft side o...
Similar Products
