HM&FC Fiberglass White Exhaust Header wrap 50 Feet(L) 2 Inch (L) with 10 Stainless Zip Ties;

A couple reasons to consider this upgrade: this wrap will help protect your wallet by increasing efficiency of the everyday vehicle. extends engine life instant fuel savings, higher mpg proven to reduce under hood heat by up to 70% easily installed by the novice and pro alike will reduce turbo lag will increase horsepower protects under hood wiring & electronics keeps the engine compartment cooler, protecting plastic parts, hoses, wiring etc from dry rot and early break down. use as a turbo wrap instead of a 400$ blanket wrap hot hoses supercharger hardware and more Also a great way to hide bluing, weld lines or just plain ugly pipes on older or custom made pipes installation: wear gloves and a long sleeve shirt to prevent itching/and irritation. wrap will smoke lightly after initial installation (just few minutes). starting at the flange end leave about ?"- ?" for hardware. each wrap should overlap the previous layer by approximately ?"- ?" turns and curves will have bit more of an overlap. try to keep the wrap as snug as possible as you go and continue to the end of the pipe. use a stainless steel tie at both ends to hold wrap in place.