Adafruit Brass M2.5 Standoffs for Pi HATs - Black Plated - Pack of 2 [ADA2336];
Adafruit Brass M2.5 Standoffs for Pi HATs - Black Plated - Pack of 2 [ADA2336]

" These go to eleven ."  11 millimeters that is!

Our  Black Plated M/F Brass Standoffs  are engineered specifically to keep your Pi HAT snug on your Pi while also keeping the two boards separated, in par...

Buy Now From Amazon

" These go to eleven ."  11 millimeters that is!

Our  Black Plated M/F Brass Standoffs  are engineered specifically to keep your Pi HAT snug on your Pi while also keeping the two boards separated, in particular the HDMI port. These standoffs can also be screwed into each other allowing stacking multiple HATs on to one Pi! They're the perfect companion for any Pi Hat combo.

Each order comes with two standoffs and two hex nuts.

Raspberry Pi and Pi HATs are not included!

 

 



Similar Products

Alchemy Power Inc. Pi-EzConnect. Raspberry Pi 2 and Raspberry Pi 3 GPIO connector. A HAT to connect GPIOs and sensors to Raspberry a Pi-2 or Pi-3.Ribbon Cable - 10 wire (15ft)Gikfun 4 Color 10mm Clear LED Light Lamp For Arduino (Pack of 20pcs) EK1045_Raspberry Pi Camera Module V2 - 8 Megapixel,1080pAketek 3x Solderless BreadBoard, 400 tie-points, 4 power rails, 3.3 x 2.1 x 0.3in (84 x 54 x 9mm)Kalevel 120pcs Breadboards Jumper Wires Male to Female Jumper Wires Male to Male Jumper Wires Female to Female Jumper Wires Kit Long Ribbon Cable 20cm (m-m, f-f, m-f )Sonline 50x Through Hole Carbon Film Resistors 220 Ohm 1/4W 5%Adafruit DC & Stepper Motor HAT for Raspberry Pi - Mini Kit