Here are the Steps to replace your cutters
Step 1:
Screw off the original cutters, remember the specific position of each cutter.
Note: Please grease it before putting the new cutters on if there is dust.
Step 2:
Close the jaws tight enough, put the replacement cutters on as the original goes. Tighten the screws a little bit with Allen Wrench.
Note: Do not screw it too tight.
Step 3:
Adjust the cutters a little bit if they are not on the right position. Fully tighten the screws. Your new cutters are good to use then.
- If you are requiring the similar or same replacement cutters as the ones on Piscifun Fishing Pliers, then this is what you need.
- As cleanly as Piscifun original pliers cutters.
- Strong and durable Tungsten Carbide makes the cutters exceptional sharp.
- Easily cut the strongest braided lines, the heaviest mono leader, the fly lines and backing lines.
- Fit the pliers which have the similar cutters as the ones on Piscifun Pliers. Please read through the Description Part for "How to replace the cutter".
- If you are requiring the similar or same replacement cutters as the ones on Piscifun Fishing Pliers, then this is what you need.
- As cleanly as Piscifun original pliers cutters.
- Strong and durable Tungsten Carbide makes the cutters exceptional sharp.
- Easily cut the strongest braided lines, the heaviest mono leader, the fly lines and backing lines.
- Fit the pliers which have the similar cutters as the ones on Piscifun Pliers. Please read through the Description Part for "How to replace the cutter".
