Installation instruction:
1.Loosen the drain light
2.Run the cable leads thru the garboard drain opening and screw the drain plug light assembly into the existing garboard fitting .The garboard fitting is 1/2 NPT.
3.Connecting the light wire to a 12-24V on/off switch. Plug in the waterproof connector.
4.Attach the red lead the positive(+) with the included in line 3 AMP assembly fuse and the black lead to the negative. (-)
5.Switch on the light to check if it works well.
Packing include:
1* Drain Plug light
1*protective tube
Remark: Lights are for underwater use only; do not operate it out of water
Note: 1.be careful with the outlet holes and please do not push the wire inside too hard and do not twist too tightly. Standard ½"NPT joint can be easily intalled by your hands
2. Please use the light under the water and the test output must be DC12-24V. If not, the light will shut off in a few minute as it is overheated design
3. Please don't use any tools (like pliers and knife) to intalls the light as it may destroy the protecitve layer
4. Please don't press the outgoing bulke or shake the wire hardly, or it will damage the driver
5. In order to avoid the short, please connect the protective tube as the image and testing the light under water.
- Single LED 1.5W with 6 LED insides, total 9W super brightness. Bronze housing materials, 100% anti-corrosion.
- Standard "1/2" NPT thread type, connected with 2 meters cable.
- Connected with waterproof connector in order to easy installation, no drilling hole are needed, just screw it into the holes on your boat.
- Waterproof: IP68. Color: Red.Connect to 12-24V battery or power sources only. Current working: 750MA, Luminous Flux 650 Lm.
- Note: 1. Standard ½"NPT joint can be easily intalled by your hands 2. Please use the light under the water and the test output must be DC12-24V. If not, the light will shut off in a few minute as it is overheated design 3. Please don't use any tools (like pliers and knife) to intalls the light as it may destroy the protecitve layer 4. Please don’t press the outgoing bulke or shake the wire hardly, or it will damage the driver
- Single LED 1.5W with 6 LED insides, total 9W super brightness. Bronze housing materials, 100% anti-corrosion.
- Standard "1/2" NPT thread type, connected with 2 meters cable.
- Connected with waterproof connector in order to easy installation, no drilling hole are needed, just screw it into the holes on your boat.
- Waterproof: IP68. Color: Red.Connect to 12-24V battery or power sources only. Current working: 750MA, Luminous Flux 650 Lm.
- Note: 1. Standard ½"NPT joint can be easily intalled by your hands 2. Please use the light under the water and the test output must be DC12-24V. If not, the light will shut off in a few minute as it is overheated design 3. Please don't use any tools (like pliers and knife) to intalls the light as it may destroy the protecitve layer 4. Please don’t press the outgoing bulke or shake the wire hardly, or it will damage the driver
