Highly flexible stranded No. 30 bare copper conductor insulated with high grade EPDM. A paper separator is utilized to enchange stripability. Maximum conductor operating temperature is 105°C in circuits not exceeding 600 volts. Minimum temperature rating -50°C. In addition to welding applications, TEMCo Easy-Flex welding cable can also be used in car audio & battery installations, RV & golf cart wiring, solar & inverter wiring, battery banks and any other use that requires rugged, highly flexible cable.
Note: If more than 1 length of wire is bought, 99% of the time it will be shipped on the same roll. Example, if a 10 ft length and a 25 ft length are bought, then you would receive 35 ft on one but cut into the lengths that are bought.
- 205 Max Amps (up to 50 feet), Rated up to 600 volts, -58°F to +221°F (-50°C to +105°C)
- TEMCo Easy-Flex has a rugged EPDM jacket and is highly flexible. Annealed 30 gauge OFC (Oxygen Free Copper) conductor.
- Nominal OD: 0.413 inches (10.49 mm), Conductor stranding: 624/30
- Resistant to Cuts, Tears, Abrasion, Water, Oil, Grease and Flame.
- In addition to welding applications, TEMCo Easy-Flex can be used for battery and starter cables for car/truck/diesel, car audio, solar, RV/camper/van DC systems, winch power leads, battery banks and much more.
- 205 Max Amps (up to 50 feet), Rated up to 600 volts, -58°F to +221°F (-50°C to +105°C)
- TEMCo Easy-Flex has a rugged EPDM jacket and is highly flexible. Annealed 30 gauge OFC (Oxygen Free Copper) conductor.
- Nominal OD: 0.413 inches (10.49 mm), Conductor stranding: 624/30
- Resistant to Cuts, Tears, Abrasion, Water, Oil, Grease and Flame.
- In addition to welding applications, TEMCo Easy-Flex can be used for battery and starter cables for car/truck/diesel, car audio, solar, RV/camper/van DC systems, winch power leads, battery banks and much more.