This is the tap and tap-drill needed to drill out a broken stud, or to chase the threads before you install new hardware in your 4.6, 5.4 or 6.8 liter Ford cylinder heads. Both the drill and tap are quality High Speed Steel ...

Buy Now From Amazon

This is the tap and tap-drill needed to drill out a broken stud, or to chase the threads before you install new hardware in your 4.6, 5.4 or 6.8 liter Ford cylinder heads. Both the drill and tap are quality High Speed Steel (not carbon steel like you find in most hardware stores), but remember, these studs have seen thousands of heat cycles, which means they are pretty hard, so here are some important tips: start with one or two smaller size drillls and work up to the tap-drill, use plenty of oil, and keep the RPMs low to medium. Remember that cutting tools are brittle and can break, so take your time! NOTE: For clarification, these are meant for use on threads that secure the exhaust manifold to the cylinder head. You will receive one tap and one drill Please note we also sell stainless steel exhaust manifold stud kits for 4.6, 5.4 and 6.8 liter Ford engines.

Similar Products

Ford 6.8 Liter V10 Stainless Exhaust Manifold Studs, Stud KitRemflex 3023 Exhaust Gasket for Ford V10 Engine, (Set of 2)Shop Iron 16023 3/8Ford 4.6 & 5.4 Liter V8 Stainless Exhaust Manifold Studs Stud KitLisle 68500 Manifold Drill Template (for Ford 2V & 3V)Dorman 03411 Exhaust Manifold Stud and NutDorman 674-694 Exhaust Manifold KitDorman 03131 Exhaust Flange Hardware Kit