Indusco clips are intended for use in making eye termination in right regular lay wire rope. Such an assembly is for non-critical light duty use where a small applied load is expected. For this reason, an efficiency of the termination is not stated. Cast iron base. Steel U-bolt and nuts. Not for overhead lifting. Failure to read, understand and follow these instructions may cause injury and property damage. Never use malleable clips for critical, heavy duty or overhead loads, such as lifting slings, support lines, guy lines, towing lines, tie downs, scaffolds, etc. Malleable clips are to be used for making eye termination assemblies, only with right regular lay wire rope, only for non-critical light duty uses with small applied loads, such as hand rails, fencing, guard rails, etc. Apply first load to test the assembly. This load should be of equal or greater weight than loads expected in use. Next, check and retighten nuts to recommended torque. 3/8-inches trade size. Minimum number of clips per eye: 3. Amount of rope to turn back: 9-1/2-inches. Required torque: 30 feet pounds. Meets Design Requirements According to Federal Specification FFC 450D, Type 1, Class 2.
Indusco clips are intended for use in making eye termination in right regular lay wire rope. Such an assembly is for non-critical light duty use where a small applied load is expected. For this reason, an efficiency of the t...
Similar Products
