Gates 18791 Molded Heater Hose

Molded Coolant Hose Gates Molded Coolant Hose is Manufactured to Fit Specific Applications Recommend for upper lower by-pass heater and other coolant hose applications Heat and ozone resistant cover Engineered to resist electrochemical degradation - the leading cause of hose failure Re-engineered materials resist vacuum collapse; this reduces the need for internal springs in many applications SAE 20R4 and 20R3 Type EC Class D-1 and D-2 specifications Temperature rating: -40° F to 275° F (-40° C to 135° C) in coolant hose applications Note: Gates recommends replacing standard worm drive and spring loaded clamps with Gates PowerGrip SB Clamps each time a new coolant hose is installed. Caution: Do not use for fuel or oil transfer applications

Specifically-engineered materials resist collapse under vacuum
Engineered to resist electrochemical degradation, the leading cause of hose failure
Pre-shaped to fit and to ensure perfectly sealed conditions
EPDM tube; synthetic fiber knit reinforcement; heat-, ozone- and chemical coolant-resistant EPDM cover
Meets requirements of SAE 20R4, class D2 and DIN 73411, class A (except for tolerances)
Specifically-engineered materials resist collapse under vacuum
Engineered to resist electrochemical degradation, the leading cause of hose failure
Pre-shaped to fit and to ensure perfectly sealed conditions
EPDM tube; synthetic fiber knit reinforcement; heat-, ozone- and chemical coolant-resistant EPDM cover
Meets requirements of SAE 20R4, class D2 and DIN 73411, class A (except for tolerances)

Top WaffleMaker Reviews

Premium Molded Coolant Hose;