Replacement Handle Pair for Revere Ware Pots/Dutch Ovens (Single Screw);

These are replacement handles for newer era (post 1968) Revere Ware pots and Dutch ovens (the ones with one screw per handle that screw directly at a 90 degree angle into the side of the pot). These handles are made for Revere Ware pots made in the last few decades that have handles that look the same, and will not fit any other model of Revere Ware pots, or pots from any other maker. These parts are newly manufactured and are made to look and work just like original Revere Ware pot handles.

These handles are not general replacement pot handles.

Material: Bakelite, stainless steel Includes:

Included: Each order includes two handles, enough for one pot.

Measurements: Approximately 3.0 in (75.5 mm) x 1.25 (32 mm) x 1.5 in in (38 mm)

Fits: Newer era pots and Dutch ovens that use a single screw only, that screws at a 90 degree angle into a bracket on the side of the pot. If your pot handles look like these, they should fit.

Replaces: The original Revere part number for this part was 36134.

Part Notes: The screws included with these handles are Phillips head, not slotted like some of the original Revere Ware pot handle screws were. Because the original slot head screws strip very easily, we consider this an improvement.

Bakelite notes: Because Bakelite is somewhat brittle, over tightening can cause the Bakelite to crack. Use caution when tightening.

Use and care: These handles (and Bakelite in general) are not oven-safe and repeated washing in a dishwasher will dull the surface of the Bakelite.

Use care to not expose the handles to open flame buy turning a gas flame on too high as it will case the Bakelite to smoke and emit a bad odor, and possibly crack. Bakelite in general is not safe to expose to an open flame.