Oatey? Master Flash? Roof Flashings are designed for use with profiled roofing materials and can be installed on every type of roofing surface. The base is designed to form a seal on any panel configuration and roof pitch, regardless of pipe location. Master Flash is pliable so it won't crack or break. It accommodates vibration, pipe movement caused by expansion and contraction, and snow-load movemnet. Master flash is made of EPDM and compounded specifically for maximum resistance to weathering due to ozone and ultraviolet light.
- 1/2 in.–4 in. Retro Master Flash EPDM roof flashing, non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays
- 8 in. x 8 in. soft aluminum base for profiled metal roofs, flexible base conforms to most flat or contoured roof surfaces including clay tile and metal roofs, sliding over vent pipe with pitch from 0-45°
- Easily customized to accommodate use on multiple pipe sizes
- Most commonly used with an existing roof penetration, when installing a flashing over the pipe is not an option and requires a hard-to-reach or wrap-around installation
- Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors
- 1/2 in.–4 in. Retro Master Flash EPDM roof flashing, non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays
- 8 in. x 8 in. soft aluminum base for profiled metal roofs, flexible base conforms to most flat or contoured roof surfaces including clay tile and metal roofs, sliding over vent pipe with pitch from 0-45°
- Easily customized to accommodate use on multiple pipe sizes
- Most commonly used with an existing roof penetration, when installing a flashing over the pipe is not an option and requires a hard-to-reach or wrap-around installation
- Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors
