This silicone O-ring is red in color, round in shape, has a durometer of 7OA, and is designed for use in a wide variety of sealing applications.

Silicone is acceptable for temperature applications between -65 degr...

Buy Now From Amazon

This silicone O-ring is red in color, round in shape, has a durometer of 7OA, and is designed for use in a wide variety of sealing applications.

Silicone is acceptable for temperature applications between -65 degrees F (-54 degrees C) to 450 degrees F (232 degrees C). It has good resistance to ozone, weather, detergent, salt water, engine and transmission oil, non-petroleum brake fluid, hydraulic fluids that resist fire, vegetable and animal oils, and high molecular weight chlorinated aromatic hydrocarbons. Silicone is vulnerable to mechanical wear and tear, water and steam over 250 degrees F (121 degrees C), aromatic hydrocarbons (benzene), chlorinated hydrocarbons (trichloroethylene), acids and bases, and hydrocarbon fuels.

O-rings commonly provide a pressure and fluid seal between cylindrically shaped, overlapping mating surfaces and are commonly seen in engines, faucets, flanges, valves, and various cylinders. They are circular in shape, with a round cross section and a hole in the center, similar to a doughnut. O-rings are available in a number of sizes, and can be ordered based on required nominal inside diameter (ID), outer diameter (OD), and cross-sectional (CS) diameter.

This silicone O-ring has a shore durometer of 70A. Shore durometer is the hardness of a material, and its resistance to permanent indentation. A higher durometer value indicates greater resistance to indentation on a scale of 0 to 100, with 100 indicating no indentation.

This silicone O-ring meets standards defined by Aerospace Standard AS568A, which is the Aerospace Size Standard for O-rings.



  • Made of silicone for use with a variety of chemicals and fluids
  • Can be used across a wide temperature range from -65 degrees F (-54 degrees C) to 450 degrees F (232 degrees C)
  • Round in cross-section to provide a seal between cylindrical overlapping surfaces
  • Durometer (hardness) of 70A for resistance to penetration
  • Meets standards defined by Aerospace Standard AS568A
  • Made of silicone for use with a variety of chemicals and fluids
  • Can be used across a wide temperature range from -65 degrees F (-54 degrees C) to 450 degrees F (232 degrees C)
  • Round in cross-section to provide a seal between cylindrical overlapping surfaces
  • Durometer (hardness) of 70A for resistance to penetration
  • Meets standards defined by Aerospace Standard AS568A

Similar Products

Dernord Cast Pipe Fitting Stainless Steel 304 Hex Locknut 1 Inch NPT Female (Pack of 2)Stainless Steel 304 Cast Pipe Fitting, Hex Locknut, MSS SP-114, 1/218-8 Stainless Steel Round Shim, Unpolished (Mill) Finish, Annealed, Hard Temper, ASTM A666, 0.075Dernord 120V 1500W Foldback Water Heater Element with Low Watt DensityDERNORD 120V 1650W Foldback Water Heater Element Screw-In Lime Life Heating Element with Low Watt Density18-8 Stainless Steel Round Shim, Unpolished (Mill) Finish, Annealed, Hard Temper, ASTM A666, 0.062DERNORD Cast Pipe Fitting Stainless Steel 304 Hex Locknut NPT Female (1DERNORD Cast Pipe Fitting Stainless Steel 304 Hex Locknut 1/2 Inch NPT Female (Pack of 2)